打印本文 打印本文  关闭窗口 关闭窗口  
JUNIPER 初始化配置命令
作者:啊祖  文章来源:本站原创  点击数4046  更新时间:2015-4-22 18:48:31  文章录入:admin  责任编辑:admin

quickstart
This will erase any existing config. Continue? [n]: y
Answer the following questions. Enter '?' for help. ^C to break out
System Name [WLC8]:
Country Code [US]: cn
System IP address []: 192.168.1.10
System IP address netmask []: 255.255.255.0
Default route []: 192.168.1.1
Do you need to use 802.1Q tagged ports for connectivity on the default VLAN? [n]
: n
Enable Webview   [y]:
Admin username [admin]: admin
Admin password [mandatory]:admin(不会显示)
Enable password [optional]:
Do you wish to set the time? [y]: n
Do you wish to configure wireless? [y]: n
----------------------------------------------------------------------
set service-profile H4-2 ssid-name H4-2
set service-profile H4-2 wep key-index 1 key 0123456789
set service-profile H4-2 auth-fallthru last-resort
set service-profile H4-2 attr vlan-name default
set radio-profile default service-profile H4-2
set ap auto mode enable
set port poe 1-6 enable

save configuration

打印本文 打印本文  关闭窗口 关闭窗口